DIGITAL THERMOMETER AT100

AT100 thermometer is designed to measure the temperature of liquids, gases, and solids in the enviroment's temperature ranging from -50°C to 400°C.

The device is protected by a special industrial casing made of ABS material that characterizes with a very high mechanical durability. In the thermometer's construction there are special insulations used, thanks to which it is waterproof as well as dust and dirt resistant.

The measuring is performed with the use of a ST01 probe with a platinum temperature sensor built in. The probe is equipped with a 1 meter long connecting wire. The result of measuring is shown on a 3-element LCD display. If the result is negative, a minus will be added before the temperature value. The probe's silicone cable characterizes with high mechanical and temperature durability. It is resistant to temperature ranging from -50°C to 200°C. To turn on/off the thermometer a modern membrane keyboard is used, that completely protects the device from liquids that may get into like water, milk, fat etc.. To feed the thermometer it is recommended to use alkaline batteries of 9V voltage, the ones of reputable producers are strongly advised. The alkaline battery's life span for such device equals about 500 hours. The thermometer controls battery consumption automatically. A „LOBAT” message displayed in the upper-left corner of a device's display means that the battery is low and it should be replaced by a new one.

AT-100 digital thermometer is calibrated with the use of DTI 1000 control thermometer of Ametek Jofra Instruments production (serial number 008954-01159) that complies with the UE's standard Declaration of Conformity. The high quality of the thermometer and compliance of its technical data was confirmed by Regional Verification Office in Krakow in a Calibration Certificate no. 97/561 issued on 06.08.1997.

The ST01 probe's Health Quality Certification issued by Polish National Institute of Hygiene (PDF 340KB)